Bay State Harley Pullers.com

2008: Schedule Photos: 2007 Season | Past Seasons Video: 2003 Event Video Clips

Motorcycle pullers

Specifications (by class)

*The rules & specifications listed below are for the Easyriders & Great American Motorcycle Rodeo Series. The Northeast Motorcycle Pullers Racing Assn (NEMPRA) by L.H.R. Entertainment is allowing any motorcycle manufacturer to become involved in the sport. Click here for the NEMPRA Series Rules

New: The How To's on Building a Trike Puller

______Solo Gas Class:____________________Gas Trike Class:___________________Fuel Trike Class:_____

Solo Class (specifications):

1. Motorcycle must be equipped with a Harley Davidson, Indian, or Victory Motorcycle V-Twin engine(s), and has to be built of at least 25% Harley Davidson, Indian or Victory Motorcycle parts or (HD, Indian, or Victory aftermarket parts)

2. The motorcycle's wheelbase cannot exceed 92 inches, and the combined weight of the rider, bike, and equipment cannot exceed 1,000lbs for either Gas class or Fuel class. The staff must approve any motorcycle before it can compete. Competitors may be weighed after each run as the request of the staff.

A. Gas Class - may use pump gas only

3. Motorcycle must be equipped with rubber tires. Nothing can be attached to the tires (ie: chains, studs, steel, etc.) The maximum tire diameter is 30". Dual tires are not allowed.

4. Motorcycle must have a functioning kill switch

5. The hitch device will be a ring measuring 2" inside diameter, and it must be no higher than the centerline of the front axle, nor farther than 24" from the center of the rear axle.

6. No part of the motorcycle may interfere with the sled or hitch during the pull.

7. All competitors are required to wear goggles or glasses during the pull. Helmets are optional.

8. Each bike may only be used in 1 class.

Trike Fuel/Gas Class

A. Gas Class - may use pump gas only ---- B. Fuel Class - may use nitrous oxide, nitromethane, or alcohol as fuel

1. Trike must be equipped with a Harley Davidson, Indian or Victory Motorcycle V-Twin engine(s), and has to be built of at least 25% Harley Davidson, Indian or Victory Motorcycle parts or (HD, Indian, or Victory aftermarket parts)

2. The Trike's wheelbase cannot exceed 92 inches, and the combined weight of the rider, bike, and equipment cannot exceed 1,000lbs for either Gas class or Fuel class. The staff must approve any motorcycle before it can compete. Competitors may be weighed after each run as the request of the staff.

3. Trike must be equipped with rubber tires. Nothing can be attached to the tires (ie: chains, studs, steel, etc.) The maximum tire diameter is 30". Dual rear wheels are allowed.

4. Trike must have a functioning kill switch

5. The competitor must provide his/her own hitch device. The hitch device will be a ring measuring 2 inches inside diameter, and it must be no more than 15" off the ground, nor farther than 15" from the center of the rear axle to the hooking point.

6. No part of the trike may interfere with the sled or hitch during the pull.

7. All competitors are required to wear goggles during the pull. Helmets are optional.

**For more detailed information on the Rules & Specifications as well as how to get involved in the sport of Motorcycle Pulling:

Contact Us. We can email over additional information. Con tact Us